ATech Machine ZETA-02 A Manual do Utilizador descarregar pdf (Página 11)

Operating and Safety Instructions

4. TRANSPORT OF THE MACHINE

* The transport should be done by qualified personnel only.

4.1. The machine should be transported by lifting with proper equipment (not

touching the ground during the transport).

4.2. The Machine is delivered wrapped in nylon as packaging, unless other form

of packing is agreed upon with the

customer.

4.3. For the weight and overall dimensions of the machine see Page 32.

5. INSTALLATION OF THE MACHINE

Necessary air and electrical facilities should be organized by the customer.

5.1. PREPERATION

5.1.1. The machine's dimension are shown in the Technical Features page (Page

33). The ground, where the machine will be placed, should be even, solid

enough to bear the weight of the machine.

5.1.2. The machine should be located approx. 50 cm away from the back wall.

5.1.3. As a conveyor will be installed to its lateral surface, you should leave a

distance equal to the conveyor length

5.2. ELECTRIC CONNECTION

5.2.1 The three-phase electric cable socket has to be in accordance with the

socket on the machine.

5.2.2 The operating voltage is 400V 50 Hz. Check the supply voltage.

5.2.3 Use grounded sockets.

5.2.4. Check the supply voltage. The supply voltage must be in accordance with

the data stipulated on the machine’s type label.

5.2.5. The electric connections have to be made by a qualified electrician, the

rotation direction of the milling cutters has to be observed by starting the

machine. If the milling cutters rotate in reverse direction, the socket connections

have to be checked and re-connected properly.

IMPORTANT !

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

Sem comentários

ATech Machine ZETA-02 A Manual do Utilizador Página 11